btrfs-send(8) ============= NAME ---- btrfs-send - send data of subvolume(s) to stdout/file. SYNOPSIS -------- *btrfs send* [-ve] [-p ] [-c ] [-f ] [...] DESCRIPTION ----------- Sends the subvolume(s) specified by to stdout. By default, this will send the whole subvolume. To do an incremental send, use '-p '. If you want to allow btrfs to clone from any additional local snapshots, use '-c ' (multiple times where applicable). You must not specify clone sources unless you guarantee that these snapshots are exactly in the same state on both sides, the sender and the receiver. It is allowed to omit the '-p ' option when '-c ' options are given, in which case *btrfs send* will determine a suitable parent among the clone sources itself. `Options` -v:: Enable verbose debug output. Each occurrence of this option increases the verbose level more. -e:: If sending multiple subvols at once, use the new format and omit the between the subvols. -p :: Send an incremental stream from to . -c :: Use this snapshot as a clone source for an incremental send (multiple allowed). -f :: Output is normally written to stdout. To write to a file, use this option. An alternative would be to use pipes. EXIT STATUS ----------- *btrfs send* returns a zero exist status if it succeeds. Non zero is returned in case of failure. AVAILABILITY ------------ *btrfs* is part of btrfs-progs. Please refer to the btrfs wiki http://btrfs.wiki.kernel.org for further details. SEE ALSO -------- `mkfs.btrfs`(8), `btrfs-receive`(8)