diff options
Diffstat (limited to 'src/udev/README')
| -rw-r--r-- | src/udev/README | 101 |
1 files changed, 101 insertions, 0 deletions
diff --git a/src/udev/README b/src/udev/README new file mode 100644 index 000000000..38459c6b2 --- /dev/null +++ b/src/udev/README @@ -0,0 +1,101 @@ +udev - Linux userspace device management + +Integrating udev in the system has complex dependencies and may differ from +distribution to distribution. A system may not be able to boot up or work +reliably without a properly installed udev version. The upstream udev project +does not recommend replacing a distro's udev installation with the upstream +version. + +The upstream udev project's set of default rules may require a most recent +kernel release to work properly. + +Tools and rules shipped by udev are not public API and may change at any time. +Never call any private tool in /usr/lib/udev from any external application; it +might just go away in the next release. Access to udev information is only offered +by udevadm and libudev. Tools and rules in /usr/lib/udev and the entire contents +of the /run/udev directory are private to udev and do change whenever needed. + +Requirements: + - Version 2.6.34 of the Linux kernel with sysfs, procfs, signalfd, inotify, + unix domain sockets, networking and hotplug enabled + + - Some architectures might need a later kernel, that supports accept4(), + or need to backport the accept4() syscall wiring in the kernel. + + - These options are required: + CONFIG_DEVTMPFS=y + CONFIG_HOTPLUG=y + CONFIG_INOTIFY_USER=y + CONFIG_NET=y + CONFIG_PROC_FS=y + CONFIG_SIGNALFD=y + CONFIG_SYSFS=y + CONFIG_SYSFS_DEPRECATED*=n + CONFIG_UEVENT_HELPER_PATH="" + + - These options might be needed: + CONFIG_BLK_DEV_BSG=y (SCSI devices) + CONFIG_TMPFS_POSIX_ACL=y (user ACLs for device nodes) + + - The /dev directory needs the 'devtmpfs' filesystem mounted. + Udev only manages the permissions and ownership of the + kernel-provided device nodes, and possibly creates additional symlinks. + + - Udev requires /run to be writable, which is usually done by mounting a + 'tmpfs' filesystem. + + - This version of udev does not work properly with the CONFIG_SYSFS_DEPRECATED* + option enabled. + + - The deprecated hotplug helper /sbin/hotplug should be disabled in the + kernel configuration, it is not needed today, and may render the system + unusable because the kernel may create too many processes in parallel + so that the system runs out-of-memory. + + - The proc filesystem must be mounted on /proc, and the sysfs filesystem must + be mounted at /sys. No other locations are supported by a standard + udev installation. + + - The default rule sset requires the following group names resolvable at udev startup: + disk, cdrom, floppy, tape, audio, video, lp, tty, dialout, and kmem. + Especially in LDAP setups, it is required that getgrnam() be able to resolve + these group names with only the rootfs mounted and while no network is + available. + + - Some udev extras have external dependencies like: + libglib2, usbutils, pciutils, and gperf. + All these extras can be disabled with configure options. + +Setup: + - The udev daemon should be started to handle device events sent by the kernel. + During bootup, the events for already existing devices can be replayed, so + that they are configured by udev. The systemd service files contain the + needed commands to start the udev daemon and the coldplug sequence. + + - Restarting the daemon never applies any rules to existing devices. + + - New/changed rule files are picked up automatically; there is usually no + daemon restart or signal needed. + +Operation: + - Based on events the kernel sends out on device creation/removal, udev + creates/removes device nodes and symlinks in the /dev directory. + + - All kernel events are matched against a set of specified rules, which + possibly hook into the event processing and load required kernel + modules to set up devices. For all devices, the kernel exports a major/minor + number; if needed, udev creates a device node with the default kernel + device name. If specified, udev applies permissions/ownership to the device + node, creates additional symlinks pointing to the node, and executes + programs to handle the device. + + - The events udev handles, and the information udev merges into its device + database, can be accessed with libudev: + http://www.kernel.org/pub/linux/utils/kernel/hotplug/libudev/ + http://www.kernel.org/pub/linux/utils/kernel/hotplug/gudev/ + +For more details about udev and udev rules, see the udev man pages: + http://www.kernel.org/pub/linux/utils/kernel/hotplug/udev/ + +Please direct any comment/question to the linux-hotplug mailing list at: + linux-hotplug@vger.kernel.org |