blob: 6646a03ea5e91da1c265adf1c9518f2520dae486 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
|
This is radsecproxy 1.4.1 from June 11 2010.
radsecproxy is a generic RADIUS proxy that can support various RADIUS
clients over UDP or TLS (RadSec).
It should build on most Linux and BSD platforms by simply typing
"./configure && make". It is possible to specify which RADIUS
transport the build should support. Without any special options to
configure, all transports supported by the system will be enabled.
See the output from "configure --help" for how to change this.
To use radsecproxy you need to create a config file which normally is
called "/etc/radsecproxy.conf". You can also specify the location
with the "-c" command line option (see below). For further
instructions, please see the enclosed example file and the
documentation at
http://software.uninett.no/radsecproxy/?page=documentation
There are five options that may be specified on the command line:
"-c configfile" to specify a non-default config file path.
"-d loglevel" to set a loglevel of 1, 2, 3, 4 and 5 where 5 is the
most detailed.
"-f" to run the proxy in the foreground with logging to stderr.
Without "-f" the default is to detach as a daemon and log to
syslog.
"-v" just prints version information and exits.
"-p" (pretend) makes the proxy go through the configuration files as
normal, but stops before creating any sockets or doing any
serious work. This is useful for validating config files.
|
